QM BenchQuality engineering tools

Lean manufacturing tools

Lean means delivering what the customer needs with as little waste as possible: the right pace, flow instead of piles, short changeovers and standards that everybody follows. These free tools calculate the numbers behind it, and the simulators show why it works.

By Ľubomír Blažek · Process quality team leader, automotive · updated 2026-11-14

Flow and pace

Make the line run at the pace of customer demand and keep material flowing.

Losses and stability

Find where time and quality are lost before you change the layout.

Standards and improvement

Organise the workplace, make the best method the standard and solve problems on one page.

Learn and practise

The eight wastes

Lean looks at a process through the eyes of the customer: only work that changes the product in a way the customer pays for adds value. Everything else is either necessary for now (inspection, some transport) or waste. The eight wastes are often remembered as TIMWOODS:

  • Transport: moving material without adding value
  • Inventory: material waiting between steps
  • Motion: walking, reaching, searching
  • Waiting: people or machines waiting for material, information or a decision
  • Overproduction: making more or earlier than needed, the waste that hides all others
  • Overprocessing: more work or precision than the customer needs
  • Defects: scrap, rework, sorting and complaints
  • Skills: not using the ideas and knowledge of the people

Where to start

Start with the pace: calculate takt time and compare it with what each station really needs. The Yamazumi chart shows which stations are overloaded and how much of their time is waste. Then look at the losses at the bottleneck with OEE, shorten the changeovers that force large batches with SMED, and connect the processes with kanban instead of schedules pushed from the office.

Every improvement ends in a standard: a work instruction for the new sequence, a 5S standard for the workplace and a short audit that checks both. Without the standard, the line drifts back within weeks.

Lean and Six Sigma

Lean removes waste and speeds up flow; Six Sigma reduces variation and defects with data. Most plants use both: lean to see and remove the obvious waste quickly, Six Sigma when a problem needs statistics to find its cause. See the Six Sigma hub for the DMAIC roadmap.

Coming to this section

  • · Future-state VSM next to the current state
  • · Yamazumi for several product variants
  • · Kaizen event planner

Missing a tool you need? Write to info@qmbench.com.

Frequently asked questions

What is lean manufacturing?

A way of running production that focuses on what the customer values and removes everything else. It grew out of the Toyota Production System and rests on two pillars: just in time (making only what is needed, when it is needed) and jidoka (stopping and fixing problems immediately instead of passing them on).

Which lean tool should I use first?

Usually a value stream walk and takt time. They show where the process does not keep pace with demand and where material waits. 5S is a good first step on a workplace that is visibly disorganised, because it makes the next problems visible.

Are these lean tools really free?

Yes. All calculators run in your browser, need no account and export a PDF. Your data is not uploaded.

What is the difference between takt time and cycle time?

Takt time is the pace the customer demands, available time divided by demand. Cycle time is how long a station actually needs per piece. A line meets demand when every station’s cycle time is at or below takt.

How do lean and OEE fit together?

OEE measures how much of the planned time a machine produces good parts at full speed. Its three factors point to lean tools: availability to SMED and maintenance, performance to small stops and standard work, quality to problem solving.

Other areas:Six SigmaShop floor managementQuality inspectionSupplier qualityAPQP